High Speed Research (HSR). -- Photographed on: 07/23/98. -- Material samples, patterns and molds. Engine nacelle outer surface pattern and mold. Upper and lower horizontal tail patterns and molds. Horizontal tail mold. Experimentation in fabrication of RCV. Technician verifying height requirements for test specimens. Honeycomb cores with epoxolite filled ends. Cured fiberglass pre-preg panel. Cured fiberglass pre-preg panel with temp/time chart. Cured fiberglass pre-preg panel "B". Forward set-off being fabricated on NC equipment. Set-off assembly and fuselage halves. Patterns for the fuselage. Top: Prototype composite fuselage. Middle: Cured fiberglass pre-preg panel. Bottom: Test of film adhesives. Flutter wing bend test specimens (fiberglass). Technicians cutting fiberglass pre-preg. Technicians assembling fibergalss pre-preg into test coupons. Technician cutting fiberglass unitape pre-preg. Technician trimming fiberglass unitape pre-preg. Technician adjusting orientation of fiberglass unitape pre-preg. Photographed in building 1238B - model shop.